Design and Implementation of a Novel Transformer less DC to DC Converter for LED Display Application
T.Deepika Vinothini, Velammal College of Engineering and Technology; R. Kiruthika ,; P. Padmadevi ,; P. Uma Devi ,
non isolated, current ripple reduction, voltage boosting. low voltage stress, automatic current sharing system, power factor correction.
This paper uses high frequency transformer less chopper with voltage boosting and low stress. The topology uses automatic current sharing capability and voltage summing at the output terminal by lower value of MOSFET, diodes. In addition to this proposed technology losses are reduced. Blocking capacitor introduces automatic current sharing in the circuit because of charge balance in the capacitor. The proposed topology provides voltage boosting with no extreme duty cycle. In relating to the existing proposed system voltage gain is proposed. Electrolytic capacitor used to reduce the current ripple .By having more current ripple will reduce the output port power in the circuit .Incase if output diode stress greater than the output voltage efficiency of circuit reduces for high output voltage application. The reduction of voltage stress and voltage gain can be achieved using ultra high step-up convertor with addition to power factor correction by voltage doubler circuit.
-
[1] Jianwu Zeng, Student Member, An Isolated Multiport DC–DC Converter for Simultaneous Power Management of Different Renewable Energy Sources IEEE, Wei Qiao, Senior Member, IEEE
[2] “Novel high step-up DC–DC converter with coupled-inductor and voltage-doubling circuits,” L. S. Yang, T. J. Liang, H. C. Lee, and J. F. Chen, IEEE Trans. Ind. Electron.
[3] “Wind/solar hybrid generation-based roadway microgrids,” W. Qiao, A. Sharma, J. Hudgins, E. Jones, and L. Rilett, in Proc. IEEE Power Energy Soc.
[4] “Family of multiport bidirectional DC-DC converters,” H. Tao, A. Kotsopoulos, J. Duarte, and M. Hendrix, IEE Proc. Electr. Power Appl
[5] “A novel multi-port DC-DC converter for hybrid energy distributed generation systems connected to power grid,” M. Qiang, Z. Xu, and W. Wu,in Proc. IEEE Int. Conf. Ind. Technol.,
[6] “Transformerless DC–DC converters with high step-up voltage gain,” L. S. Yang, T. J. Liang, and J. F. Chen, IEEE Trans. Ind. Electron
[7] “High step-up soft-switched converters using voltage multiplier cells,” S. Lee,S. Choi, IEEE Trans. Power Electron.,
[8] “Interleaved high Step-Up ZVTconverter with built-in transformer voltage doubling cell for distributed PVgeneration system,” W. Li, X. Xiang, C. Li,W. Li, and X. He,IEEE Trans. Ind. Electron
[9] “Switched-Capacitor-Cell-Based voltage multipliers and DC–AC inverters,” Z. Ke, M. J. Scott, and W. Jin, IEEE Trans. Ind. Appl.
[10] “A review of the single phase photovoltaic module integrated converter topologies with different DC link configurations,” Q. Li and P. Wolfs,IEEE Trans. Power Electron.,
[11] “Integrated MPPT and battery charger for PV application using one multiphase interleaved three-port DC-DC converter,” Z. Wang and H. Li,, in Proc. IEEE Appl. Power Electron. Conf. Exposit
[12] “An isolated three-port bidirectional chopper with decoupled power flow management,” C. Zhao, S. Round, and J. Kolar,IEEE Trans.Power Electron
Paper ID: GRDCF002100
Published in: Conference : International Conference on Innovations in Engineering and Technology (ICIET - 2016)
Page(s): 312 - 316
Published in: Conference : International Conference on Innovations in Engineering and Technology (ICIET - 2016)
Page(s): 312 - 316